Complete Solution

for Passive Fire Protection

One stop solution for all your construction project requirements.

Intumescent Paint

Load-bearing capacity of steel decreases above 550 °C. Beam lose their strength to the extent that the structure can suffer damage and if the worst happens, the structure could collapse.

Our Intumescent paint coating start to swell at about 180-200 °C and forms a foam layer which stops the critical heating of steel. It is available as water and
solvent base paints.


Download Catalogue

Cementitious Coating

Cementitious fire protection is normally applied by spray using special equipment to protect structural steel or concrete from the effects of fire for a nominal fire resistance period.

The fireproofing Cementitious coating has excellent physical properties for interior/architectural uses and Cementitious coat can give up to 4 hours fire protection.

Protecting Steel Elements via spray mortar guarantee the bearing capacity of the metal structures from R30 to R240. It is tested under UNE ENV 13381-4.

  • Mix Concrete/profile sheet protection quick and economical solution for the protection of this type of slabs up to REI 120. Tests carried out under UNE ENV 13381-5 & 13381-4.
  • Large Format Partition Wall is protected to gain extensive fire resistance capabilities to the separation walls to comply the structure with UNE EN 1364-1.

 


Download Catalogue

Cable Coating

Fire resistant able coating is applied to avoid fire spread on electrical equipments and to encapsulate fire loads.

Key features:

  • Water-proof
  • Solvent and halogen free
  • Elastic, non hygroscopic
  • Protects release of toxic fumes
  • UV-light resistant
  • Tested against Gamma radiation
  • Ageing resistant
  • No maintenance required

Download Catalogue

Inquiry
Wall/Cable Penetration Seal

Fire resistant and smoke tight, High-quality system for penetrations through massive walls and plasterboard walls as well as for floors.

Tested and approved according to national and international standards as e.g.: DIN 4102, EN 1366, BS 476 and other standards on request.

  • Installation and handling in accordance with the installation instruction/finished drawings and the approval of trained specialists.
  • The installation, according to the approval, is easy to handle and possible with a basic tool kit.
  • A high-quality system made of special mortar for penetrations through massive walls and floors.

Download Catalogue